Setting The Audit Log Facility - Hitachi XP P9500 User Manual

Value (severity)
2
3
4
5
6
7
Table 3-18 Values Indicating Audit Log Data Categories on page 3-76
describes the values that indicate audit log data categories. The default is
all.
Value
ss
a
ca
all
This example shows how to enable the collection of audit log data:
# /usr/DynamicLinkManager/bin/dlnkmgr set -audlog on -audlv 6 -
category all
Specify on if you want to collect audit log data, and off if you do not want to
collect audit log data. If you specify on, you can use the -audlv parameter to
specify the collection level for audit log data and the -category parameter to
specify the audit log categories.
If you want to set the audit log facility, see
page 3-76.

Setting the Audit Log Facility

The following describes how to specify the output destination for audit log
data.
If you want to specify the output destination for audit log data, first specify
the audit log facility by using the dlnkmgr set -audfac command. Next,
define the output destination of the facility in the /etc/syslog.conf file.
Table 3-19 Values Indicating Audit Log Facility on page 3-77
values that indicate audit log facility. The default is user.
3-76
Critical-level audit log data is collected.
Critical-level and Error-level audit log data is collected.
Critical-level, Error-level, and Warning-level audit log data is
collected.
Critical-level, Error-level, Warning-level, and Informational-level
audit log data is collected.
Table 3-18 Values Indicating Audit Log Data Categories
Audit log events of the StartStop category are collected.
Audit log events of the Authentication category are collected.
Audit log events of the ConfigurationAccess category are collected.
Audit log events of the StartStop, Authentication, and
ConfigurationAccess categories are all collected.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for AIX(R))
Explanation
Explanation
Setting the Audit Log Facility on
describes the