Webtools Functionality Moved To Dcfm - HP StorageWorks 1606 - Extension SAN Switch Release Note

Miscellaneous
After changing domain offset followed by issuing an hafailover command on a DC SAN Backbone
Director, DC04 SAN Director, or 4/256 SAN Director running FOS 6.3 in interopmode 2, the console
log may generate continuous Unknown LSR type messages. You must either reboot the switch or
issue another hafailover command to terminate the messages.
During non-disruptive firmware upgrades, E_Ports in R-RDY mode may cause some frame drops on
the E-Port links.

WebTools functionality moved to DCFM

The functionality that was moved from WebTools 6.1.1 to DCFM applies to all versions of DCFM and
also applies to 6.3.x.
Table 9 WebTools functionality in DCFM
Function
Add unzoned devices
Analyze zone config
Define device alias
Device accessibility matrix
Fabric events
Fabric summary
Table 9 describes these changes.
WebTools 6.1.0
Zone Admin
Zone Admin
Zone Admin
Zone Admin
Monitor > Fabric events
Reports > Fabric summary
DCFM
Configure > Zoning
Reverse Find in the zoning dialog
provides the view of the zoned
and unzoned devices in the fabric
if all zone members are selected
for Find.
Configure > Zoning:
Reverse Find in the zoning dialog
provides the view of the zoned
and unzoned devices in the fabric
if all zone members are selected
for Find.
Device Tree and Topology:
Connected End Devices: Custom
display from the top level in the
main frame provides the device
tree and topology view for all the
zoned devices if all zones are
selected in the active zone
configuration.
Configure > Zoning
Configure > Zoning
The Compare dialog provides the
Storage-Host and Host-Storage
view in a tree representation that
is comparable to the Device
Accessibility Matrix when all
devices are selected.
Monitor > Logs > Events
Monitor > Reports > Fabric
Summary report
HP StorageWorks FOS 6.3.0b Release Notes
Comments
37