HP StorageWorks 1606 - Extension SAN Switch Release Note page 53

If configdownload is performed via DCFM, switch authentication failure
may be seen.
Add FIP version 0 handling.
Address configdownload problems.
Due to race condition, daemons may panic during FID deletion and
creating without significant time delay in between.
Cold-failover within Port group for F_Port didn't happen on Access
Gateway (AG).
Supportsave may show parity errors on disabled ports.
Switch Admin: Merge status dialog should display the status and
timestamp of last merge for FCoE Login.
Switch panic in kernel while access an iu that has already timedout
and freed.
Hosts on 4Gb SAN switch for HP c-Class BladeSystem in Access
Gateway-mode lost their targets when failover happened from 1 trunk
group (with primary ports) to another trunk group (with shared area
ports) on 8Gb 48 port blade of DC SAN Director.
WebTools shows no SFP details for CEE interfaces.
On Enabling LLDP status and assigning FCoE priority bits globally, is
not getting reflected in Port Admin window.
Confusing error message when copying a source configuration from
a remote server.
Defect ID: DEFECT000247893 Summary: Port Auto Disable - Ports
outside of given range are being enabled.
IPv6 Address dropped from ag --show.
Port statistics details are not getting refreshed for EX ports.
Fixed in FOS 6.3.0
Workaround prior to code change:
Issue hafailover or hareboot.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Use the CLI interface.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Do clean-up before downloading a
new CEE configuration: 1. In cmsh,
run "write erase" to clear
startup-config. 2. Reboot switch by
running "reboot" on FOS prompt. 3.
In cmsh, use "copy" command to
copy backup configuration into
running-config.
Fixed in FOS 6.3.0
Workaround prior to code change:
Enable and disable port auto disable
for ports one at a time.
Fixed in FOS 6.3.0
Workaround prior to code change:
Issue switchdisable/enable causes the
IPv6 Address again to be presented.
Fixed in FOS 6.3.0
HP StorageWorks FOS 6.3.0b Release Notes 53