HP StorageWorks 1606 - Extension SAN Switch Release Note page 16

Hp storageworks fos 6.3.0b release notes (5697-0360, april 2010)
Hide thumbs Also See for StorageWorks 1606 - Extension SAN Switch:
Table of Contents

Advertisement

StorageWorks Merging Fabrics Based on M-series and B-series Fibre Channel Switches Application
Notes, available at http://www.hp.com.
4
When routing to an M-EOS edge fabric using frame redirection, the fabric must have a FOS-based
product in order to configure the frame redirection zone information.
5
When directly attached to a host or target that is part of an encryption flow.
6
Products operating with FOS versions earlier than 5.3.1b or 6.1.0e cannot participate in a logical
fabric that is using XISLs (in the base fabric).
7
These platforms cannot be directly attached to hosts or targets for encryption flows.
8
SANRouters 1620 and 2640 should not be used with XPath or FOS-based routing (FCR) for
connections to the same edge fabric.
9
Using HP StorageWorks Fabric Manager (FM) 5.5 or earlier with FOS 6.1.1 or later can result in
problems with Zoning, Performance monitoring, SYSLOG configuration, FICON wizards, IOD Delay,
AAA replication, Port enable/disable and other functions. Unless you are using Admin Domains, HP
recommends that you upgrade to HP StorageWorks Data Center Fabric Manager (DCFM) 10.3.x to
use with FOS 6.1.1 or later. However, if you are using Admin Domains, HP recommends that you
downgrade FOS to 6.1.0h.
10
Fabric Manager is not supported with FOS 6.3.x.
4/256 SAN Director blade support
FOS 6.3.0a is fully qualified and supports the Director blades listed in
Table 2 4/256 SAN Director blade support matrix
Director blade
FC4-16
FC4-32
FC4-48
FC8-16
FC8-32
FC8-48
FC10-6
FC4-16IP (iSCSI blade)
FR4-18i (FCIP/FC Router blade)
16
Table
Number of blades
Supported with any mix, with up to eight blades of each
type. No intermix restrictions. The 4/256 SAN Director
must run FOS 6.0.0b or later to support the FC8-16 port
blade, and FOS 6.1.0a or later to support the FC8-32
and FC8-48 port blades.
Up to four blades of this type
Up to two blades of this type. Up to eight FR4-18i blades
can be installed if they are used only for FC FastWrite
or FCIP without routing.
2.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks fos 6.3.0b

Table of Contents