HP StorageWorks 1606 - Extension SAN Switch Release Note page 61

If TI zone operations are performed simultaneously on different
switches, active CP may failover due to termination of Name server
module.
4Gb switch running at fixed 2Gb speed may not respond to FLOGI
from HBA using auto-speed negotiation.
Detected termination of management server daemon during stress
testing on DC SAN Director with 8 logical switches.
FOS-FVT- If a Read is Sent Busy Status and the Subsequent Seek is also
Sent Busy, Mis-Compares To the Host.
Downloading config file between switches causes license lost.
Inconsistent display of urouteshow trying to map to invalid FCR user
port while topologyshow is not showing those routes.
If user account on RADIUS server is set up with only Chassis level role
as primary, but it is not on the LF role list, the user cannot login.
Missing Pause and Resume for EX port having MiI10K Edge Fabric in
239 Domain - works for domain 209-238.
While performing security related fabric wide operations if fabric be-
comes unstable, user might observe verify on standby.
Setting the E-Net portname on the Primary CP does not get copied
over to the standby CP.
NPIV devices on a single port are spread across effective and McDATA
default configurations, only devices from default configuration can
establish communication.
Access Gateways connected to EOSc in a mixed fabric (FOS and
EOS) are not shown in DCFM.
Fixed in FOS 6.3.0
Workaround prior to code change:
No workaround needed, the DC SAN
Director CP fails over non-disruptively
and retains all configuration data.
Fixed in FOS 6.3.0
Workaround prior to code change:
Lock the port to fixed speed.
Fixed in FOS 6.3.0
Workaround prior to code change:
Wait for system to stabilize after
executing bladedisable and before
issuing hafailover or disable MS
platform services while performing
stress testing.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Do the following to back up licenses:
1. Execute licenseshow command
save the licenses into a file outside the
switch. 2. Then perform
configdownload. 3. Add the licenses
saved in step one.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Specify LF role list in the RADIUS
server for the account.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
System will recover.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Do not overlap effective and default
zones on the same NPIV port,
following best practices guidelines.
Fixed in FOS 6.3.0
HP StorageWorks FOS 6.3.0b Release Notes 61