HP StorageWorks 1606 - Extension SAN Switch Release Note page 55

Hp storageworks fos 6.3.0b release notes (5697-0360, april 2010)
Hide thumbs Also See for StorageWorks 1606 - Extension SAN Switch:
Table of Contents

Advertisement

Detected termination of 0.weblinker.fcg:1315.
LUN state became disabled with reason "Key not in sync" after 12
hour run of stress test KV link failure/restore with online rekey.
Devices attached to AG are not considered as Virtual.
Persistently disabled GE port on a Multiprotocol Router Blade becomes
disabled after hafailover.
rcsd terminated on 8/80 SAN Switch during a configDownload on
all switches in the fabric.
Key id sate shows "key expired: Allowing data append" while key
lifespan = 0 minute.
Rekey operation is restarted but hung after all the Encryption Engines
(EEs) in the encryption group are rebooted.
LUN state shows target offline after disconnect/reconnected both initi-
ator and target.
Containers for 4/32B SAN Switch not ready for discover LUN.
FOS 6.2 Radius Calling-station-ID (31) implementation is used for both
"device called by" and "workstation called from" hostname/IP address.
2408 FCoE CN Switch has issues interoperating with Foundry FCX
and FESX LACP.
Pre-Discovery: Containers did not failback after firmware download
to 6.2.0 D patch build 6.
FVT: DEK key on member node shows " waiting for new key from peer'
after rekey.
fdmid terminated quietly after 2408 FCoE CN Switch run for a week
while no operations executed but light background FCoE/FC traffic.
When configdefault command entered portlog.ptdbgdisable should
get a default value.
RFE: Port Admin: Port Bind should only require the middle 2 bytes,
since the error message says the last 2 must be 0x00.
Switches bouncing between reachable/unreachable in edge fabric
after change EX port trunk into E port trunk.
Following a reboot of all nodes in an Encryption Group (EG) with
current and pending rekeys, single rekey session did not resume.
Verify fab_ha.c line 5206 on 10G Adva link connect.
"Enable Inactive port" tab in the EZmanager has to be disabled for
the 2408 FCoE CN Switch.
8/8 or 8/16 SAN Switch not responding to Link Reset primitives cor-
rectly.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
HP StorageWorks FOS 6.3.0b Release Notes
55

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks fos 6.3.0b

Table of Contents