Download Print this page

HP StorageWorks 1606 - Extension SAN Switch Release Note page 62

Hp storageworks fos 6.3.0b release notes (5697-0360, april 2010)
Hide thumbs

Advertisement

Not able to add EE monitor on port 1 after firmware upgrade from
6.1.0c to 6.2.0 on 400 Multiprotocol router.
Nsinfo.htm returns NPIV info as Physical if non-VF switch is connected
to VF enabled platform.
CP experienced a kenel panic "Oops: kernel access of bad area, sig:
11 [#1]".
Fruclass in fru table and fruhistoryclass in fruhistorytable of HA MIB
shows other(1) for CP slot instead of cp(4) for DC SAN Director and
DC04 SAN Director.
CPstatus change trap is not generated on issuing HA failover for 4/256
SAN Director, but the failover happens and the CP status change oid
returns changed values.
FOS CLI doesn't allow Port fencing policy addition for F_Port when
there are no F_ports on the switch.
Not getting GbE ports while performing EnumerateAssociatedInstances
on Brocade_LogicalSwitch.
Switch doesn't commit after firmwareDownload fail as 0x23 (time out).
Appropriate message is not shown in the message box, when the
"Details" button in the "Service" tab of "HA" window is clicked.
High Availability: The error message thrown is not relevant or mean-
ingful, when the values for E_D_TOV and R_D_TOV in the "Configure"
tab of "Switch admin", are changed.
Incorrect output from agshow command.
Detected termination of zoned observed running repeated multiple
zone updates for several hours in different FIDs.
FICON FCIP Acceleration error - FCCU LinkBusy from non-Busy CU in
ReadStates.
Found 2 LUNs got disabled with "Rekey done with failure" after
overnight manual_rekey finished. [CVLC-1001], 775/57, SLOT 2 |
FID 128, Nept_74, Manual re-key failed, LUN SN.
With Safezoning disabled, enabling defaultzoning via WT post con-
cerning messages that Safezoning was disable and defaultzoning was
enabled.
62
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change: A.
DCFM can be used to add the port
fencing policy for F_Port. B. Existing
FOS CLI can always be used to add
port fencing policy after bringing up
F_Port on a switch. Adding port
fencing policy for F_Port makes sense
only when there are F ports on a
switch and anyway the existing CLI
behaviour takes care of this.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Re-enable LUN.
Fixed in FOS 6.3.0

Advertisement

loading

  Also See for HP StorageWorks 1606 - Extension SAN Switch

  Related Manuals for HP StorageWorks 1606 - Extension SAN Switch

This manual is also suitable for:

Storageworks fos 6.3.0b