Webtools Functionality Moved To Dcfm - HP StorageWorks 4/8 - SAN Switch Release Note

Fabric OS version
Fabric OS 6.1.2x
Note: HP does not support
Fabric OS 6.1.2c.
Mode:

WebTools functionality moved to DCFM

The functionality that was moved from WebTools in 6.1.1 to DCFM is applicable to both DCFM
Professional and DCFM Enterprise.
Table 8 WebTools functionality in DCFM
Function
Add unzoned devices
Analyze zone config
Define device alias
Device accessibility matrix
Fabric events
All 8-Gb switches (except 8-Gb SAN Switch for HP BladeSystem c-
Class and EVA4400 embedded switch module, which do not support
v6.1.2x)
Added the ability to change portcfgfillword to IDLE or ARB(FF) mode.
Regardless of the Fabric OS version that was previously installed, all ports
default to IDLE [mode 0]. However if they were changed to ARB(FF) [mode
1] manually, they remain in ARB(FF) mode. Can be changed by the user.
0—IDLE for Link Init, IDLE for fill word
1—ARB(FF) for Link Init, ARB(FF) for fill word (NOTE: not supported with XP
storage arrays)
Table 8 describes these changes.
WebTools 6.1.0
Zone Admin
Zone Admin
Zone Admin
Zone Admin
Monitor > Fabric events
HP StorageWorks Fabric OS 6.1.2b release notes
DCFM
Configure > Zoning
Reverse Find in the zoning dialog
provides the view of the zoned
and unzoned devices in the fabric
if all zone members are selected
for Find.
Configure > Zoning:
Reverse Find in the zoning dialog
provides the view of the zoned
and unzoned devices in the fabric
if all zone members are selected
for Find.
Device Tree and Topology:
Connected End Devices: Custom
display from the top level in the
main frame provides the device
tree and topology view for all the
zoned devices if all zones are
selected in the active zone
configuration.
Configure > Zoning
Configure > Zoning
The Compare dialog provides the
Storage-Host and Host-Storage
view in a tree representation that
is comparable to the Device
Accessibility Matrix when all
devices are selected.
Monitor > Logs > Events
Comments
21