HP StorageWorks 1606 - Extension SAN Switch Release Note page 68

Rare Instances of warm recovery failure during upgrade due to small
timing window in library used by some services.
Fabstateshow log wrapping overwrites useful fabstate data on the
switch when interoperating with McDATA switches.
Data miscompare during path failover in active/passive array.
About the Severity Level on FOS Message Reference.
I/O timeouts observed during first time re-key of disk LUNs
Adding a tapepool (commit) cause hacluster failover even the (container
owner) switch is still disabled.
Error message may be seen on console under heavy utilization of in-
terface to key vault.
Re-key starts and host IO is blocked on failover/failback with mis-
matched time on EE nodes.
FOS-FVT- Check Condition Not Propagated On Read to Physical Initi-
ator (PI).
FCIP tape pipelining does not propagate task retry identification (TRI).
Several harmless messages gets generated when DCFM tries to discover
a large fabric.
During stress-to-fail testing of Cold Start/Recovery on a switch with
multiple Logical Switches, the local Name Server misses some device
entries.
Same device ( WWN ) is visiable in more than 2 fabric using VF
function and VT not getting imported.
Port Auto Disable - Wrong message when disabling port auto disable.
After few hafailovers, FC fast write I/O times out and a few unexpected
frame drops are seen on 1 to 2 ports out of 7-8 ports running.
Desired distance is editable for the long distance mode L0:Normal
initially when the page loads.
68
Fixed in FOS 6.3.0
Workaround prior to code change:
Issue an additional reboot or
hafailover.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Disable FCIP Tapepipelining.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Perform switchdisable/enable on the
affected switches.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Disable FCFW feature or limit the
number of HA Failover sequences to
times when IO is not active.
Fixed in FOS 6.3.0