HP StorageWorks 1606 - Extension SAN Switch Release Note page 54

WebTools Switch Admin: QoS: User defined priority group 0-7 does
not show up in the drop down for priority group id.
8/8 or 8/16 returned invalid value for 'swFCPortFlag' MIB object
from 8/8 or 8/16 on SNMP manager.
MAC learning/flushing times are very slow on 2408 FCoE CN Switch
Switch.
Switch crashed on sending LOGO from Finisar LT.
Virtual Fabrics 6.2.0c when XISL use is enabled base logical switch
in switchshow shows Allow XISL Use as "off" open RFE 1249.
Modify fipcfg --advintvl cli to reject non-zero values for FKA interval.
CUP needs to send an RSCN after coming back online after a cold
boot.
WT: FCoE connected devices tab, sort order of Device WWN is incor-
rect.
In an FCR environment, switch runs out of memory when connected
with EoS switches.
Blades are not shown in when a slot is hot plugged in to a DC SAN
Director or DC04 SAN Director.
With VF, deleting a FID while in the FID leads to undesirable conditions.
The user is stuck in the FID and all commands run generate an error
message.
FOS still reports some FRU failures as link incidents on port 0xFF.
After FCoE login, FOS v6.1.2_cee does not filter packets with SRC-
MAC=FCF-MAC.
Reboot of all 4 nodes in an Encryption Group (EG) with multiple rekeys
pending resulted in new rekey sessions being unable to start.
IPFC address is shown instead of chasis IP address in SNMP Trap for
DC04 SAN Director.
Required detailed error description while the port enable/disable fails.
Man page/online help on "fcoelogingroup --create xxx" should replace
allow-all by "allowall."
Pathinfo command failure occurs when run on FOS 6.1, if the path
traverses through FOS 6.2.x.
2408 FCoE CN Switch should be able to set enable password.
When Quality of Service (QoS) is enabled by default / not utilized,
performance of the SAN drops. Disable QoS by default on 4Gb plat-
forms, 8Gb long-distance and make portcfg values such as fill words,
trunk information persistent across upgrade/downgrades.
54
Fixed in FOS 6.3.0
Workaround prior to code change:
Use CLI to map user defined priority
group to a CoS.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0