HP StorageWorks 1606 - Extension SAN Switch Release Note page 66

During stress test of deleting and creating DCC policies on LS, a assert
was observed on the console.
When FSPF database in edge fabric has an obsolete domain ID that
duplicates to front domain for a newly merged switch, front domain
fails to form completely in the edge fabric.
When using pathinfo in MetaSAN, where the destination domain
queried overlaps with intermediate hop/domain, output of this com-
mand is not accurate.
Date cmd should be rejected on non-Default LS.
"Updating Flash" Console Message is seen on all FOS Switches in
Fabric during Configupload on Single FOS Switch in a Interopmode
2 fabric.
Block user from configuring QoS on 6-port 10Gb ISL blade.
Inappropriate error message from configuredownload in VF mode and
LSAN zone tag /LSAN matrix is not cleared when the config file con-
tains no entry for them.
In one rare case, 'zoneobjectrename' command failed without reason.
Changing configuration using configure or configDownload when
systemVerification is executed could lock out the systemVerification
from being executed subsequently.
Channel definition errors; time out on QSA Response due to excessive
link incidents.
The ifNumber does not match the number of entries in the ifTable for
the logical switches with LISL.
Newly created LS should inherit NTP server setting of Default LS.
Allowed to add a F_Port TT Monitor to mirror port, however no counters
display.
Virtual nodes on the same switch port may not be able to communicate
due to missing RSCNs and the CAM not be programmed. This is not
a likely scenario.
66
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Portdisable and portenable EX_Port.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Change date only on the default
switch.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Please ignore the error message and
use CLI to clear LSAN tag and LSAN
binding.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Do not update the configuration when
systemVerification is running. If user
accidentally changes configuration
when the command was executing,
use "burninlevel 0" to recover from
this situation.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Don't use date command in
non-default logical swtich.
Fixed in FOS 6.3.0
Fixed in FOS 6.3.0
Workaround prior to code change:
Toggle the physical port.