Sort Caa Copy Group Statistics Panel - HP StorageWorks P9000 Reference Manual

NOTE:
Before displaying CAA performance information in this panel, Usage Monitor should have
started from Remote Web Console. If the copy group consists of USPV volumes only, there is
no need to start Usage Monitor.
For Pri-SN and Sec-SN, information acquired from the storage system is displayed. If the copy
direction is opposite from the direction specified in the copy group definition file, the secondary
and primary storage system serial numbers in the copy group definition file are shown in order
for Pri-SN and Sec-SN.
The columns where information is not acquired by the storage system and the columns for
copy groups that contain a copy pair whose copy type is not CAA might display N/A because
the values for those columns are not guaranteed.
When you display the CAJ data transfer rate in this panel, it is necessary that the Usage
Monitor for the control unit (to which the journal volume used by the copy group definition
file belongs) has been started from Remote Web Console, and that the data capture interval
of this Usage Monitor is ten minutes or less.
If information cannot be acquired from the Sec-Array, the RSF Tot, RSF C/T, and WPR Tot
columns in Sec %s display N/A.
If information cannot be acquired from the Pri-Array, the SFT, RSF Tot, RSF C/T, WPR Tot and
TRANS Kbytes/s columns in Pri %s, and OFLD min and RCUR min columns in TIMERS display
N/A.
If an operation is performed on each copy pair or the copy pair directions in the copy group
are mixed, the value for the copy group cannot be guaranteed because the copy pair direction
statuses in the copy group do not match. Match the copy pair statuses and copy pair directions
in the copy group and then re-execute.
You can use the LOCATE and SORT commands in the CAA Copy Group Performance Statistics
panel. For details about how to use each command, see
You can specify the following fields for a sort key of the SORT command:
Name of field
PRSFTOT
PRSFCT
PWPRTOT
SRSFTOT
SRSFCT
SWPRTOT
TRANS
PSN
SSN

Sort CAA Copy Group Statistics Panel

In the CAA Copy Group Performance Statistics panel, if you press F6=Sort, the Sort CAA Copy
Group Statistics panel for specifying the sorting order is displayed.
Figure 105 (page 127)
126 ISPF Panels
Sorted by
Pri-SN reserved sidefile cache-usage rate
Pri-SN reserved sidefile cache-usage rate for CT
Pri-SN write pending rate
Sec-SN reserved sidefile cache-usage rate
Sec-SN reserved sidefile cache-usage rate for CT
Sec-SN write pending rate
Data transfer rate between Pri-SN and Sec-SN sites (KB/s)
Storage system serial number of the Pri-SN
Storage system serial number of the Sec-SN
shows the Sort CAA Copy Group Statistics panel.
"Command Line Commands" (page 11).
Direction
Ascending
Ascending
Ascending
Ascending
Ascending
Ascending
Ascending
Ascending
Ascending