Scan Remote Device Address Extent Panel; Route Config Panel - HP StorageWorks P9000 Reference Manual
Business continuity manager software reference guide
Hide thumbs
Also See for StorageWorks P9000:
- Manual (333 pages) ,
- User manual (322 pages) ,
- Reference manual (236 pages)
Table of Contents
Advertisement
Table 21 Contents of the Command Control Address (CCA) Selection List Panel (continued)
Item
Device Number
Volume Serial Number
Scan Remote Device Address Extent Panel
In the Discover HP Storage System panel, when you specify r in AC in the remote storage system,
the Scan Remote Device Address Extent panel for executing the remote scan is displayed.
Figure 28 (page 42)
Figure 28 Scan Remote Device Address Extent Panel
Table 22 (page 42)
Table 22 Contents of the Scan Remote Device Address Extent Panel
Item
Remote Device Address
Domain
Storage System S/N
Device Address
1
Do not include any volumes that belong to a copy pair that was created by Remote Web Console. If such a volume is
included, the copy pair operations might be disabled.
When F6=Scan is pressed, volumes within the specified values are scanned. If an invalid character
is specified, or if the value specified for Start is greater than the value specified for End, an error
message prompts you to re-enter the values.
The information on the scanned disk configuration is saved in the disk configuration definition file.
Route Config Panel
The Route Config panel is displayed when 2 Route Config is selected in the Discover/Define
Configuration panel. The Route Config panel is used to define a route list.
Figure 29 (page 43)
42
ISPF Panels
Description
The number of a device
Volume serial number of a device
shows the Scan Device Address Extent panel.
describes the items in the Scan Remote Device Address Extent panel.
Description
Device Address Domain ID of the storage system that will be scanned
Serial number of the storage system that will be scanned
Specify Start and End for the device address (control unit and command control
address) range to be remotely scanned.
Specify the hexadecimal number in ascending order. If the CCA is omitted,
Start and End will be set to 00 and FF respectively.
shows the transitions of the operation panel from the Route Config panel.
1
Advertisement
Table of Contents
