Executing Ykdelpth; Path Set Status Panel (Executing Ykqrypth) - HP StorageWorks P9000 Reference Manual

Figure 95 LOAD Option Panel (When Loading a Path Set)
For Route List ID displayed in the LOAD Option panel, specify the route list ID of the route list to
be loaded (no more than 8 alphanumeric characters). Hyphens cannot be used.
Note that depending on the specifications for the Remote DKC Function column and the Preset
RouteListID column in the Set Defaults panel, the LOAD Option panel might not be displayed.
Settings of the Remote
DKC Function
Y
Y
N
1 The route list is used for all operations after the first time the path set is loaded. As such, when operating multiple path
sets, first load the path sets for which a route list is needed, and specify the route list ID used, in the LOAD Option
panel. Note that once you return to the Main Menu panel, information for the specified route list can be cleared.
Note that when you specify b or q in the AC column of the Manage Path Set panel without executing
the YKLOAD command, the Confirm Path Set Load panel (see
(page 183)) is displayed, requesting the loading of the path set.
If a device to which I/Os are issued was not set during the definition of a logical path, and the
storage system at the primary site or secondary site is connected to the host when loading a path
set, then, from the scanned disk configuration file, the system assumes a device to which I/Os are
issued when path operations are executed.

Executing YKDELPTH

If d is specified in the AC column in the Manage Path Set panel or Path Set Status panel, the
Confirm Path Delete panel (see
deletion.

Path Set Status Panel (Executing YKQRYPTH)

If q is specified in the AC column in the Manage Path Set panel, the Path Set Status panel that
displays the status of a path in a path set is displayed.
Figure 96 (page 112)
Settings of the Preset Display of the LOAD Option Panel
RouteListID
Specified Not displayed. The ROUTE parameter of the YKLOAD
command becomes the value specified for the Preset
RouteListID.
Not specified Only displayed the first time a path set is loaded.
Invalid Not displayed. The YKLOAD command is executed
without the ROUTE parameter specified.
"Confirm Path Delete Panel" (page
shows the Path Set Status panel.
"Confirm Path Set Load Panel"
182)) is displayed to confirm the
Manage Path Set Panel (Logical Path Management)
1
1 1 1