HP StorageWorks P9000 Reference Manual page 85

1 Business Continuity Manager can dissolve copy pairs (by executing the YKRECVER or YKDELETE command).
2 Although you can change the definitions in Business Continuity Manager by specifying HS or NONE for Linkage Option,
the changes will not be applied to the host and storage system. If the definitions are changed on the host or in the
storage system, make sure that you change the definitions in Business Continuity Manager so that they match the
definitions on the host and in the storage system.
3 If not all of the volume statuses are SIMPLEX, processing might not execute correctly.
4 Do not specify 0 for MIRROR ID when using a CAJ copy group and a Continuous Access Synchronous copy group in
either the 3DC Cascade configuration or the 3DC Multi-Target configuration. Note also that when a 3DC Multi-Target
configuration or a 2DC configuration with HyperSwap and CAJ is used, the mirror ID cannot be the same as any other
mirror ID assigned to another CAJ copy group.
5 When a copy group in which Y is set to FREEZE SCP changes to a failure suspension status, execute the YKRUN command
to cancel the SCP status. If you do not cancel SCP status, the update I/O flow from the host is held for a long period
of time. You cannot use the SCP delay time that was set using the Remote Web Console to change the hold period for
update I/O. Specification of Y is valid only for a CA copy group for which a consistency group ID is specified.
6 For details on the consistency group timer type, see one of the following:
HP StorageWorks P9000 Continuous Access Synchronous for Mainframe Systems User Guide
HP StorageWorks P9000 Continuous Access Synchronous User Guide
Hitachi TrueCopy for Mainframe User Guide: HP XP24000 Disk Array, HP XP20000 Disk Array
HP StorageWorks XP24000/XP20000 Continuous Access Software User Guide
7 When executing the YKRESYNC command, specify the VOLUNIT or DEVN parameter.
If the Enter key is pressed before all required attributes have been specified, an error message is
displayed.
"Default values for each copy type" (page 85)
Table 57 Default values for each copy type
Copy type Default value
BC PROT MODE=PERMIT
COPY PACE=NORMAL
CA Linkage Option=NONE
FENCE LVL=NEVER
FREEZE SCP=Y
PROT MODE=PROTECT
COPY PACE=NORMAL
TIMESTAMP=N
OPEN/MF=N
CAA ERROR LVL=GROUP
FLOW CTL=Y
DIF UNIT=CYL
PROT MODE=PROTECT
COPY PACE=NORMAL
CAJ MIRROR ID=1
ERROR LVL=GROUP
PROT MODE=PROTECT
C/T TIME MODE=ASIS
If you define a new copy group in the Add Copy Group panel, and you then return to the Copy
Group Attributes panel and press the F12=Cancel key, display returns to the Copy Group Detail
indicates the default values for each copy type:
Discover/Define Configuration Panel (Configuration File Definition) 85