Volume Query Information (Ca) Panel - HP StorageWorks P9000 Reference Manual

Table 80 Contents of the Volume Query Information (BC) Panel (continued)
Item
1 It is not displayed when the YKQRYDEV command has been executed for the HP StorageWorks XP1024/XP128 Disk
Array.
2 See the table (for BC) in the HP StorageWorks P9000 for Business Continuity Manager Software User Guide for details
about obtaining the status of the displayed copy pair using the YKQRYDEV command. Note that when the device is a
command device of either of the following models, CDEV(apid) is displayed in the Status column (apid: APID):
HP StorageWorks XP12000/XP10000 Disk Array
HP StorageWorks XP24000/XP20000 Disk Array
HP StorageWorks P9500 Disk Array
3 If the emulation type of the journal volume is OPEN, JOURNAL is not displayed.
4 The timing for when the defined values are reflected is as shown
effective.
5 It is displayed if P-VOL or S-VOL is shared with other copy pairs in the definition (for example, in a 1:n BC copy pair
configuration or when S-VOL for CAA is used as P-VOL for BC).
6 MISMATCH might be displayed. This happens when the device information during definition, as indicated by Primary
Volume and Secondary Volume, differs from the device information reported by the SSID. In this case, the device
information reported by the SSID is displayed in the Pair Volume column. If MISMATCH is displayed, check the
configuration file used and the actual storage system configuration information settings.
NOTE: N/A displays in the Device Information (DEVN) field in the following cases:
When the YKQRYDEV command returns an error
When displaying information about a device of a remote storage system if the route list has
not been loaded or the target storage system is not included in the route list
When displaying information about a Non Gen'ed volume, and the route list has not been
loaded or the target storage system is not included in the route list.

Volume Query Information (CA) Panel

If you specify q in AC on the Copy Group Pair Status panel, the YKQRYDEV command is executed
on the P-VOL and S-VOL, and the Volume Query Information (CA) panel is displayed for a CA
copy pair.
The Volume Query Information (CA) panel is shown in
140 ISPF Panels
Description
CU CU number of the volume which makes a copy
pair
CCA CCA of the volume which makes a copy pair
DEVN Device number of the volume which makes a
copy pair
inTable 56 (page 79)
Figure 1 12 (page
in the table item labeled When
141).