HP StorageWorks P9000 Reference Manual page 190

Table 100 Configuration Files That Must Be Loaded Before Command Execution (When
the Environment Does Not Contain a Non Gen'ed Volume) (continued)
Command name
YKSCAN
YKSLEEP
YKSTATS
YKSUSPND
YKWATCH
YKWTOMSG
1 You need to load the configuration file when operating a reverse-direction path.
2 When using the CA consistency preservation function (when operating a CA copy group with a consistency group ID
specified), you do not need to load the configuration file before executing the YKMAKE command. However, you need
to load the configuration file before executing other copy group operation commands.
3 You need to load the configuration file when acquiring information about an S-VOL that is not recognized by the host.
4 You need to load the configuration file when you operate a CG container with EXCTG ID specified.
5 You need to load the configuration file when the copy type is CA, CAA, or CAJ and when you specify the REVERSE
parameter.
Legend:
Y: You need to load the configuration file.
D: Whether you need to load the configuration file depends on the situation.
--: You do not need to load the configuration file.
Table 101 Configuration Files That Must Be Loaded Before Command Execution (When the
Environment Contains a Non Gen'ed Volume)
Command name
YKBLDCMD
YKBLDPTH
YKCONMSG
YKDELCMD
YKDELETE
YKDELPTH
YKERCODE
YKEWAIT
YKEXPORT
YKFCSTAT
YKFREEZE
YKH2B
YKIMPORT
YKINSCHK
190 CLI Commands
Configuration file that must be loaded
Copy group definition file
--
--
Y
Y
--
--
Copy group definition file
--
--
--
--
Y
--
--
Y
--
--
Y
--
--
--
Route list definition file
--
--
3
D
2, 5
D
--
--
Configuration file that must be loaded
Route list definition file
Y
1
D
--
Y
2
D
1
D
--
2
D
--
--
--
--
--
--
Path set definition file
--
--
--
--
--
--
Path set definition file
--
Y
--
--
--
Y
--
--
--
--
--
--
--
--