Copy Group Parameters - HP StorageWorks P9000 Reference Manual

NOTE:
The parameters can be specified for each copy group (CGID).
If a copy group parameter that is not a CGID parameter is specified more than once under a
single CGID parameter, the last time the parameter is specified takes effect.
You can specify more than one STATUS parameter under a single CGID parameter.
An error occurs if more than one CGID parameter with the same copy group ID is specified.
An error occurs if the first CGID parameter is preceded by another parameter.

Copy Group Parameters

Format
CGID=copy-group-ID
CGPREFIX=prefix
CGDAD=DADID
[CGROUTE=route-list-ID]
[CGMONSTAT={ACTIVE|INACTIVE}]
[CGSTARTUPSTATUS=startup-status,startup-action[,NOCANCEL]]
Information to be set
You can specify the startup status of a copy group that you want to monitor, and the startup action
to be executed if the copy group is not in startup status.
"Values That Can Be Specified in the Startup Status and Startup Action Parameters" (page 366)
the values that can be specified for the startup status and startup action.
Table 163 Values That Can Be Specified in the Startup Status and Startup Action Parameters
Item
Startup status
Startup action
Parameters
CGID=copy-group-ID
Specifies the copy group name.
CGPREFIX=prefix
Specifies the prefix of the copy group definition file for the copy group.
CGDAD=DADID
Specifies the host device address domain ID of the copy group.
If this parameter is omitted, no route list is used during monitoring.
CGMONSTAT={ACTIVE|INACTIVE}
Specifies the monitoring status of the copy group (whether to monitor the copy group).
ACTIVE
366 BCM Monitor Parameter Files
Value
SIMPLEX
DUPLEX
SUSPOP
HOLD
EXIT
STOP
ADJUST
lists