Debug Ip Ospf - Enterasys N Standalone (NSA) Series Configuration Manual

Routing Protocol Configuration Command Set
Configuring OSPF

13.2.3.30 debug ip ospf

Use this command to enable OSPF protocol debugging output.
debug ip ospf {subsystem}
Syntax Description
subsystem
Command Syntax of the "no" Form
The "no" form of this command disables OSPF protocol debugging output.
no debug ip ospf {subsystem}
Command Type
Router command.
Command Mode
Privileged EXEC: Matrix>Router1#
Command Defaults
None.
Example
This example shows how to enable OSPF protocol debugging output to display information about
Link State Advertisement generation:
Matrix>Router1#debug ip ospf lsa-generation
13-74 Matrix NSA Series Configuration Guide
Specifies the OSPF subsystem for which protocol
debugging will be enabled. Valid entries and their
associated outputs are:
•
adj - OSPF adjacency events
•
flood - OSPF flooding
•
lsa-generation - OSPF Link State Advertisement
generation
•
packet - OSPF packets
•
retransmission - OSPF retransmission events