Enterasys N Standalone (NSA) Series Configuration Manual page 1171

Table 14-1 provides an explanation of the command output.
Table 14-1 show radius Output Details
Output
RADIUS state
RADIUS retries
RADIUS timeout
RADIUS Server
What It Displays...
Whether the RADIUS client is enabled or disabled.
Number of retry attempts before the RADIUS server times
out. The default value of 3 can be reset using the set radius
command as described in
Maximum amount of time (in seconds) to establish contact
with the RADIUS server before retry attempts begin. The
default value of 20 can be reset using the set radius
command as described in
IP address, UDP authentication port, authentication realm
type (management, network or any), and status (whether
or not the RADIUS server has been configured).
Matrix NSA Series Configuration Guide
Security Configuration Command Set
Configuring RADIUS
Section 14.3.2.2.
Section 14.3.2.2.
14-11