Clear Multiauth Idle-Timeout - Enterasys N Standalone (NSA) Series Configuration Manual

Security Configuration Command Set
Configuring Multiple Authentication

14.3.10.13 clear multiauth idle-timeout

Use this command to clear multiple authentication idle-timeout values, for an idle session, back to
the default values for one or all authentication types. The default value is 300 seconds for all types.
clear multiauth idle-timeout [cep | dot1x | mac | pwa]
Syntax Description
cep | dot1x | mac |
pwa
Command Defaults
If no authentication type is specified, the idle timeout value is returned to 300
seconds for all authentication types.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to clear the idle-timeout session values for cep and mac authentication
types, back to default value of 300 seconds:
Matrix(rw)->clear multiauth idle-timeout cep
Matrix(rw)->clear multiauth idle-timeout mac
This example shows how to clear the idle-timeout session values for all authentication types, back
to the default value of 300 seconds:
Matrix(rw)->set multiauth idle-timeout
14-148 Matrix NSA Series Configuration Guide
(Optional) Specifies the authentication type:
•
cep — Enterasys Convergence End Point Authentication
•
dot1x— IEEE 802.1X Port-Based Network Access
Control
•
mac — Enterasys MAC Authentication
•
pwa — Enterasys Port Web Authentication