Enterasys N Standalone (NSA) Series Configuration Manual page 1215

Table 14-3 show pwa Output Details
Output
PWA Status
PWA IP Address
PWA Protocol
PWA Enhanced
Mode
PWA Logo
PWA Guest
Networking Status
PWA Guest Name Guest user name for PWA enhanced mode networking.
PWA Guest
Password
PWA Redirect
Time
Port
What It Displays...
Whether or not port web authentication is enabled or
disabled. Default state of disabled can be changed using the
set pwa command as described in
IP address of the end station from which PWA will prevent
network access until the user is authenticated. Set using the
set pwa ipaddress command as described in
Section 14.3.6.10.
Whether PWA protocol is CHAP or PAP. Default setting of
PAP can be changed using the set pwa protocol command as
described in Section
Whether PWA enhanced mode is enabled or disabled.
Default state of disabled can be changed using the set pwa
enhancedmode command as described in
Whether the Enterasys Networks logo will be displayed or
hidden at user login. Default state of enabled (displayed) can
be changed using the set pwa displaylogo command as
described in Section
Whether PWA guest user status is disabled or enabled with
RADIUS or no authentication. Default state of disabled can
be changed using the set pwa gueststatus command as
described in Section
Default value of "guest" can be changed using the set pwa
guestname command as described in
Guest user's password. Default value of an empty string can
be changed using the set pwa guestpassword command as
described in Section
Time in seconds after login success before the user is
redirected to the PWA home page. Default of 5 can be reset
using the set pwa redirecttime command as described in
Section 14.3.6.9.
PWA port designation.
Matrix NSA Series Configuration Guide
Security Configuration Command Set
Configuring Port Web Authentication (PWA)
Section
14.3.6.11.
14.3.6.8.
14.3.6.16.
Section
14.3.6.15.
14.3.6.2.
Section 14.3.6.12.
14.3.6.13.
14-55