Show Ip Policy - Enterasys N Standalone (NSA) Series Configuration Manual

14.3.13.5 show ip policy

Use this command to display the policy applied to a routing interface.
show ip policy
Syntax Description
None.
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to display policy information:
Matrix>Router1(config)#show ip policy
Interface Route map
3 103
2 102
Table 14-8
Table 14-8 show ip policy Output Details
Output
Interface
Route map
Priority
Load policy
Priority Load policy
first first-available
only round-robin
provides an explanation of the command output.
What It Displays...
Routing interface.
Route map assigned to the routing interface (using the ip
policy route-map command as described in
Section 14.3.13.6.)
How the PBR next hop selection will be prioritized. Set with
the ip policy priority command as described in
Section 14.3.13.7.
How the PBR next hop will be selected. Set with the ip
policy load-policy command as described in
Section 14.3.13.7.
Security Configuration Command Set
Configuring Policy-Based Routing
Pinger
off
on
Matrix NSA Series Configuration Guide
Interval Retries
3 3
10 4
14-177