1. Lower the fan bracket into the chassis.
2. Align the holes in the bottom of the bracket with the pins
3. Press the bracket into position until the fan-bracket release levers
4. Replace the fans (see Installing a hot-swap fan).
5. Replace the PCI riser-card assemblies and the DIMM air baffle (see Installing a PCI riser-card assembly
and Installing the DIMM air baffle).
6. Install the cover (see Completing the installation).
7. Slide the server into the rack.
8. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices and
the server.
Removing the SAS riser card and controller assembly
To remove the SAS riser-card and controller assembly from the server, complete the steps for the applicable
server model.
• 12-drive-capable server model:
2
in the bottom of the chassis.
1
click into place.
.
Chapter 6
Removing and installing FRUs
177