Lenovo ThinkServer RD220 Hardware Maintenance Manual page 101

Table 3. DSA diagnostic messages (continued)
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 7 "Parts listing, ThinkServer RD220 Type 3729, 3779, 3797, and 3798" on page 205 to determine
which components are customer replaceable units (CRU) and which components are field replaceable
units (FRU).
• If an action step is preceded by "(Trained service technician only)," that step must be performed only by
a trained service technician.
Message
number Component
202-801-xxx Memory
202-802-xxx Memory
Test State Description
Memory Aborted Internal
Stress program error.
Test
Memory Failed General error:
Stress
memory size is
Test insufficient to
run the test.
Action
1. Turn off and restart the system.
2. Make sure that the DSA code
is at the latest level. For the
latest level of DSA code, go to
http://www.ibm.com/support/docview.wss?uid=psg1SER
3. Make sure that the system UEFI code
is at the latest level. The installed
firmware level is shown in the DSA
event log in the Firmware/VPD
section for this component. For
the latest level of firmware, go to
http://www.ibm.com/support/docview.wss?uid=psg1
MIGR-4JTS2T and select your system to
display a matrix of available firmware.
4. Run the test again.
5. Turn off and restart the system if
necessary to recover from a hung state.
6. Run the memory diagnostics to identify
the specific failing DIMM.
1. Make sure that all memory is enabled by
checking the Available System Memory
in the Resource Utilization section of the
DSA event log. If necessary, enable all
memory in the Server Configuration and
Boot Management program.
2. Make sure that the DSA code
is at the latest level. For the
latest level of DSA code, go to
http://www.ibm.com/support/docview.wss?uid=psg1SER
3. Run the test again.
4. Run the standard memory test to validate
all memory.
.
Chapter 5
95
Diagnostics