Lenovo ThinkServer RD220 Hardware Maintenance Manual page 167

1
PCI riser-card assembly 2
2
PCI riser-card assembly 1
3
Alignment slots
4
Alignment brackets
5
PCI riser connector 1
6
PCI riser connector 2
• PCI riser connector 1: Carefully fit the two alignment slots on the side of the assembly onto the
two alignment brackets in the side of the chassis; align the rear of the assembly with the guides on
the rear of the server
• PCI riser connector 2: Carefully align the bottom edge (the contact edge) of the riser-card assembly
with the PCI riser-card connector on the system board; align the rear of the assembly with the guides
on the rear of the server.
10. Press down on the assembly. Make sure that the riser-card assembly is fully seated in the PCI riser-card
connector on the system board.
11. Perform any configuration tasks that are required for the adapter.
If you have other optional devices to install or remove, do so now. Otherwise, go to Completing the
installation.
.
Chapter 6 Removing and installing FRUs
161