Removing An Ethernet Adapter; Installing An Ethernet Adapter - Lenovo ThinkServer RD220 Hardware Maintenance Manual

5. Perform any configuration tasks that are required for the adapter.
6. Install the server cover (see Completing the installation).
7. Slide the server into the rack.
8. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices and
the server.

Removing an Ethernet adapter

To remove an Ethernet adapter, complete the following steps:
Step 1. Read the safety information that begins on page Chapter 2 "Safety information" on page 3 and
"Installation guidelines" on page 9.
Step 2. Turn off the server and peripheral devices and disconnect all power cords and external cables.
Step 3. Remove the cover.
Step 4. Remove the PCI riser card 1.
Step 5. Push the tabs on the adapter bracket
disconnect it from the system board. Then lift it out of the server.
Step 6. Install the cover.
Step 7. Turn on the server and reconnect the peripheral devices, power cords, and external cables.

Installing an Ethernet adapter

To install an Ethernet adapter, complete the following steps:
Step 1. Remove the adapter bracket
Step 2. Extend the Ethernet ports through the openings in the rear of the chassis.
2 outwards, then lift the front end of the adapter
2
from the new Ethernet adapter
1
.
.
Chapter 6 Removing and installing FRUs
1 to
151