Installing A Tape Drive - Lenovo ThinkServer RD220 Hardware Maintenance Manual

9. If you are instructed to return the drive, follow all packaging instructions, and use any packaging materials
for shipping that are supplied to you.

Installing a tape drive

1
SAS riser card
To install a tape drive, complete the following steps:
1. If the tape drive came with metal spacers on the installed on the sides, remove the spacers.
2. Install the drive tray on the new tape drive as shown, using the four screws that you removed from
the former drive.
1
Tape drive
2
Tray
3
Latch
3. Prepare the drive according to the instructions that come with the drive, setting any switches or jumpers.
4. Slide the tape-drive assembly most of the way into the tape-drive bay.
5. Using the cables from the former tape drive, connect the signal and power cables to the back of the
tape drive.
6. Make sure all the cables are out of the way, and slide the tape-drive assembly the rest of the way
into the tape-drive bay.
7. Push the tray handle to the closed (locked) position.
.
Chapter 6 Removing and installing FRUs
191