Removing A Cd-Rw/Dvd Drive - Lenovo ThinkServer RD220 Hardware Maintenance Manual

• The ID that is assigned to each bay is printed on the front of the server above the drive bay.
Important: Do not install a SCSI hard disk drive in this server.
1
Handle
2
Latch
3
Filler panel handle
To install a drive in a hot-swap bay, complete the following steps.
Attention: To maintain proper system cooling, do not operate the server for more than 10 minutes without
either a drive or a filler panel installed in each bay.
Step 1. Orient the drive as shown in the illustration.
Step 2. Make sure that the tray handle is open.
Step 3. Align the drive assembly with the guide rails in the bay.
Step 4. Gently push the drive assembly into the bay until the drive stops.
Step 5. Push the tray handle to the closed (locked) position.
Step 6. If the system is turned on, check the hard disk drive status LED to verify that the hard disk drive
is operating correctly.
After you replace a failed hard disk drive, the green activity LED flashes as the disk spins up. The amber LED
turns off after approximately 1 minute. If the new drive starts to rebuild, the amber LED flashes slowly, and
the green activity LED remains lit during the rebuild process. If the amber LED remains lit, see "Hard disk
drive problems" on page 125.
Note: You might have to reconfigure the disk arrays after you install hard disk drives.

Removing a CD-RW/DVD drive

To remove the CD-RW/DVD drive, complete the following steps.
188
ThinkServer RD220 Hardware Maintenance Manual