Replacing An Internal Usb Drive; Replacing A Usb Drive - Cisco SE-CL-L3 Installation Manual

Replacing an Internal USB Drive

Step 1
Power off the server and then remove the mini-storage module carrier from the server as described in
Mini-Storage Module Carrier, on page
Step 2
Remove an M.2 SSD:
a) Use a #1 Phillips-head screwdriver to remove the single screw that secures the M.2 SSD to the carrier.
b) Remove the M.2 SSD from its socket on the carrier.
Step 3 Install a new M.2 SSD:
a) Angle the M.2 SSD downward and insert the connector-end into the socket on the carrier. The M.2 SSD's label must
face up.
b) Press the M.2 SSD flat against the carrier.
c) Install the single screw that secures the end of the M.2 SSD to the carrier.
Step 4
Install the mini-storage module carrier back into the server and then power it on as described in
Module Carrier, on page
Replacing an Internal USB Drive
This section includes procedures for installing a USB drive and for enabling or disabling the internal USB
port.

Replacing a USB Drive

Caution We do not recommend that you hot-swap the internal USB drive while the server is powered on because of
the potential for data loss.
Step 1 Remove an existing internal USB drive:
a) Shut down and remove power from the server as described in
on page 27.
b) Slide the server out the front of the rack far enough so that you can remove the top cover. You might have to detach
cables from the rear panel to provide clearance.
If you cannot safely view and access the component, remove the server from the rack.
Caution
c) Remove the top cover from the server as described in
d) Locate the USB socket on the motherboard, directly in front of PCIe riser 2.
e) Grasp the USB drive and pull it horizontally to free it from the socket.
Step 2
Install a new internal USB drive:
a) Align the USB drive with the socket.
b) Push the USB drive horizontally to fully engage it with the socket.
c) Replace the top cover to the server.
d) Replace the server in the rack, replace cables, and then fully power on the server by pressing the Power button.
Cisco Application Services Engine Hardware Installation Guide
56
54.
54.
Shutting Down and Removing Power From the Server,
Removing the Server Top Cover, on page
Maintaining the Server
Replacing a
Replacing a Mini-Storage
28.