Replacing A Cisco Usb Flash Drive; Overview Of The Pre-Loaded 16-Gb Cisco Usb Flash Drive; Enabling A Pre-Loaded Cisco Usb Flash Drive Virtual Drive; Booting A Pre-Loaded Cisco Usb Flash Drive Virtual Drive - Cisco UCS C22 Installation And Service Manual

Hide thumbs Also See for UCS C22:
Table of Contents

Advertisement

Chapter 3
Maintaining the Server

Replacing a Cisco USB Flash Drive

The server has two options for USB flash drives:
This section includes the following topics:

Overview of the Pre-Loaded 16-GB Cisco USB Flash Drive

This Cisco USB flash drive is pre-loaded with three software bundles, each on one of four preconfigured
virtual drives (VDs). The fourth VD allows you to install an OS or embedded hypervisor.
The VDs are configured as follows:

Enabling a Pre-Loaded Cisco USB Flash Drive Virtual Drive

Each of the VDs on the pre-loaded Cisco USB flash drive can be separately enabled or hidden from the
host. The default as shipped from the factory is for all VDs to be hidden.
To enable VDs and expose them to the host, follow these steps:
Log in to CIMC interface for the server, using the IP address of the server.
Step 1
Navigate through GUI tabs to Server > Inventory > Storage.
Step 2
Click FlexFlash-0 in the Storage Adapters list.
Step 3
Click on Configure Operational Profile in the Actions area.
Step 4
The Operational Profile dialog opens.
Check the box for each VD that you want to enable and expose to the host, then click Save Changes.
Step 5
OL-26646-01
The server can be ordered with one blank 8-GB flash drive pre-installed in the internal USB slot.
This server can be ordered with one pre-loaded 16-GB Cisco USB flash drive that ships in the box.
This flash drive is pre-loaded with Cisco UCS C-Series Utilities.
Overview of the Pre-Loaded 16-GB Cisco USB Flash Drive, page 3-33
Enabling a Pre-Loaded Cisco USB Flash Drive Virtual Drive, page 3-33
Booting a Pre-Loaded Cisco USB Flash Drive Virtual Drive, page 3-34
Monitoring and Managing a Cisco USB Flash Drive, page 3-35
Cisco USB Flash Drive Replacement Procedure, page 3-35
Enabling or Disabling the Internal USB Port, page 3-36
Cisco UCS Server Configuration Utility (SCU).
1.
Hypervisor (HV). This is a VD that you can use for your own purposes.
2.
3.
Cisco Drivers (Drivers).
4.
Cisco Host Upgrade Utility (HUU).
Installing or Replacing Server Components
Cisco UCS C22 Server Installation and Service Guide
3-33

Advertisement

Table of Contents
loading

Table of Contents