Interface Configuration Command Set; Auto; Duplex; End - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual

Appendix C Command Summary

Interface Configuration Command Set

auto

Usage Guidelines

duplex

Syntax Description
Usage Guidelines

end

78-13124-05
Use these commands to manage the speed and duplex settings of the specified
Ethernet interface on the current Secure Content Accelerator. Enter Interface
Configuration mode by using the enable command in Non-Privileged mode and
the configure command in Privileged mode. Specify an Ethernet interface to
configure using the interface command in Configuration mode. The prompt
changes to
<config-if[interfacename]>>
Sets the current Ethernet interface to autonegotiation, canceling any existing
forced duplex or speed setting.
auto
Availability: Serial, Telnet; FIPS Mode (serial only)
Forces the current Ethernet interface to full or half duplex.
duplex <full|half>
full
half
Availability: Serial, Telnet; FIPS Mode (serial only)
Exits Interface Configuration mode and returns to Configuration mode.
end
Cisco 11000 Series Secure Content Accelerator Configuration Guide
.
Sets the current interface to full duplex.
Sets the current interface to half duplex.
Configuration Command Set
C-91