Telnet; Starting The Quickstart Wizard - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual

Starting the QuickStart Wizard

Note
Starting the QuickStart Wizard
Cisco 11000 Series Secure Content Accelerator Configuration Guide
3-4
When prompted to supply a file name during a telnet management
session, you must supply it as a URL in the form of
HOST/PATH/FILENAME using the http://, https://, ftp://, or tftp://
prefix.
After initiating a management session as described previously, start the
QuickStart wizard via a serial or telnet connection by entering these commands:
enable
quick-start
If you are using telnet, go to "Using the QuickStart Wizard" below.
If you are using a serial connection and the device has not been assigned an IP
address, you are prompted to assign a hostname and IP address before beginning
the QuickStart configuration process.
Would you like to specify a hostname and IP address for this device?:
Enter the hostname for this device:
The hostname is a user-specified device name. In this example, we use the name
myDevice. When prompted for them, enter the IP address, netmask, and default
gateway for the device. You are prompted to accept the information before
continuing with configuration.
The following configuration will be saved to the device.
Hostname
Ip address
Netmask
Default gateway addr
Is the above information correct? (y/n):
Enter y if the listing is correct. Go to "Using the QuickStart Wizard" below. Enter
n if the information is incorrect. You are prompted for the configuration
information again.
Chapter 3
: myDevice
: 10.1.11.100
: 255.255.255.0
: 10.1.11.10
Using the QuickStart Wizard
78-13124-05