Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual page 59

Chapter 3 Using the QuickStart Wizard
Enter the URL for the key as prompted. If the QuickStart wizard is unable to find
or load the file, you receive an error message and are allowed to restart key
assignment. After the key is properly loaded, configure the certificate as described
below.
To use a key already loaded into the appliance (including defaults) rather than key
on disk, type 2 when prompted to choose an option. All available keys are
displayed. Enter the name of the key to use. If you enter an invalid key name, you
receive an error message and are prompted to re-enter the key name.
After the key has been properly loaded, you are shown a summary and asked to
configure a certificate.
Each ssl-server is associated with a certificate.
1. Certificate is stored in a file on a http or ftp server.
2. Want to use an existing or default Certificate.
Choose the option corresponding to your situation (1/2):
If you have the certificate available via a URL, type 1.
Enter the name of the certificate for ssl-server 'myServer':
Enter the name to assign the certificate. This name is used for identification only.
Certificate names can consist of Arabic numerals and upper- and
Note
lowercase alphabetic, underscore (_), hyphen (-), and period (.)
characters. Certificate names must begin with an alphabetic or
underscore character and have a limit of 127 characters.
Enter URL for a PEM encoded X509 certificate file:
Enter the URL for the certificate as prompted. If the QuickStart wizard is unable
to find or load the file, you receive an error message and are allowed to restart
certificate assignment. After the certificate is properly loaded, configure a
security policy as described below.
78-13124-05
CONFIGURE SSL-SERVER 'myServer' CERT
SSL-server name : myServer
Ip address : 10.1.2.3
Secure Port : 443
Clear Port : 80
Key name : default
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Using the QuickStart Wizard
3-7