Supporting Rip; Example: Configuring Rip - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual

Supporting RIP

Supporting RIP

Example: Configuring RIP

Cisco 11000 Series Secure Content Accelerator Configuration Guide
4-26
4. Save the configuration to flash memory. If not saved, the configuration is lost
during a power cycle or when the reload command is used.
SCA# write flash
SCA#
Cisco Secure Content Accelerator devices support Routing Information Protocol
(RIP) versions 1 and 2. This example demonstrates how to enable RIP version 1
packet usage.
Initiate a management session as described previously.
1.
2. Enter Privileged and Configuration modes.
SCA> enable
SCA# configure
Enable reception and processing of RIP version 1 packets. Then return to
3.
Privileged mode.
(config[myDevice])# rip v1
(config[myDevice])# end
SCA#
Save the configuration to flash memory. If not saved, the configuration is lost
4.
during a power cycle or if the reload command is used.
SCA# write flash
SCA#
Chapter 4 Using the Configuration Manager
78-13124-05