Example: Configuring An Ethernet Interface; Figure 5-4 Resetting Ip Information Configuration Example - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual

Chapter 5 Graphical User Interface Reference
Note

Example: Configuring an Ethernet Interface

78-13124-05
Figure 5-4 Resetting IP Information Configuration Example
Click Update. The Status area tells you that the connection switches to the
3.
new address in 20 seconds.
In certain situations, such as when changing to a different subnet,
redirection might not occur. If the connection is not redirected,
manually connect to the device. If you still are unable to connect, use
the serial configuration manager to check the device configuration
and try again.
1. Click Network to activate the Network tabs.
Use the list box in the Network Interface or Server Interface panel of the
2.
Settings tab to change the Ethernet interface settings. The Settings page is
shown in Figure 5-5.
Cisco 11000 Series Secure Content Accelerator Configuration Guide
General Configuration Examples
5-9