Snmp Trap-Type Generic - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual

Configuration Command Set
Related Commands

snmp trap-type generic

Usage Guidelines
Cisco 11000 Series Secure Content Accelerator Configuration Guide
C-82
(This command must be entered on one line.) Use the no form of the command to
disable the specified event trap-type. The table below shows trap-type minimum,
maximum, and default levels for each value argument. Except in the case of
cpu-utilization, the levels indicate actual values; cpu-utilization levels indicate
percentage of use.
Trap-Type
cpu-utilization
ssl-tps
ssl-total-connections 1
no snmp (Configuration Command Set)
show snmp (Top Level Command Set)
snmp access-list (Configuration Command Set)
snmp contact (Configuration Command Set)
snmp default community (Configuration Command Set)
snmp enable (Configuration Command Set)
snmp location (Configuration Command Set)
snmp trap-host (Configuration Command Set)
snmp trap-type generic (Configuration Command Set)
Enables generic SNMP traps.
snmp trap-type generic
no snmp trap-type generic
Availability: Serial, Telnet; FIPS Mode (serial only)
Use the no form of the command to disable generic SNMP traps.
Value1 Value1 Value1
Min Max Default
1 99 75
1 2500 170
10000 600
Appendix C Command Summary
Value2 Value2 Value2
Min Max Default
1 99 90
1 2500 190
1 10000 800
78-13124-05