Performing A Preinstallation Configuration (Optional) - Cisco Catalyst Wireless 9163E Manual

Performing a Preinstallation Configuration (Optional)

• AP-mounting options: To a vertical wall or pole
Note
• AP power options: 802.3at (PoE+), 802.3af (PoE), and 802.3bt
• Operating temperature:
• Console access using the console port
Note
We recommend that you prepare a site map showing AP locations so that you can record the device MAC
addresses from each location and return them to the person who is planning or managing your wireless network.
Performing a Preinstallation Configuration (Optional)
Performing the following procedures ensures that the AP installation and the initial operation proceed as
expected. This procedure is optional.
Note
The preinstallation configuration setup is illustrated in
17:
Cisco Catalyst Wireless 9163E Access Point Hardware Installation and Deployment Guide
16
The AP can be mounted in various orientations. Depending on the orientation, you may have to purchase
additional mounting hardware. For more information, see the
• Without solar derating: -40° to 149℉ (-40° to 65℃) and 131℉ (55℃)
• With solar derating: -40° to 131℉ (-40° to 55℃) and 131℉ (55℃)
We recommend that you use a console cable that is one meter or less in length.
The AP may face issues while booting if you use an unterminated console cable
(not plugged into any device or terminal) or a console cable that is more than one
meter in length.
If your controller is configured properly, you can install the AP in its final location and connect it to the
network from there. For additional information, see
page 40.
Mounting the Access Point, on page 18
Deploying the Access Point in a Wireless Network, on
Figure 5: Preinstallation Configuration Setup, on page
Installing the Access Point
section.