Advertisement
8
Performing a Pre-Installation Configuration
The following procedures ensure that your access point installation and initial operation go as
expected. This procedure is optional.
Performing a pre-installation configuration is an optional procedure. If your network
Note
controller is properly configured, you can install your access point in its final location and
connect it to the network from there. See the
Network" section on page 23
The following Pre-Installation Configuration procedure given does not include configuring Link
Aggregation. For information on configuring Link Aggregation, see the Cisco Wireless LAN
Controller Configuration Guide, Release 8.2, at this URL:
http://www.cisco.com/c/en/us/td/docs/wireless/controller/8-2/config-guide/b_cg82.html
The pre-installation configuration setup is illustrated in
"Deploying the Access Point on the Wireless
for details.
Figure
6.
15
Hide quick links:
Advertisement
