Assigning Personal Speed Dial Codes To 5-And 10-Button Voice Terminals; Terminal - AT&T MERLIN 3070 Administration Manual

38
ASSIGNING PERSONAL SPEED DIAL CODES TO 5-AND
10-BUTTON VOICE TERMINALS
On 5- and 10-button voice terminals, you can program up to 22 Personal Speed Dial
codes instead of Outside Auto Dial buttons for frequently used numbers. Before you
can program Personal Speed Dial codes, however, you must program a Speed Dial
Access button. To program Personal Speed Dial codes and a Speed Dial Access but-
ton, follow the procedure below.
1.
Go to the voice terminal you want to program.
2. Slide the T/P switch on the left side of the voice terminal to P.
The voice terminal rings every 5 seconds to remind you it is in program mode.
3. If you already have a Speed Dial Access button, go to step 4. otherwise,
follow this procedure to program the Speed Dial Access button:
a. Label the button Speed Dial Access.
b. Touch the button.
c. Dial *94.
4.
Touch Speed Dial Access.
Dial the code you want to assign to the telephone number (available codes
5.
are 01 through 22).
6. Dial *90.
7. Dial the telephone number (16-digit maximum).
If you need them, you may use the special character codes described in
the section "Using Special Characters in Programmed Dialing Sequences,"
page 39.
8. If you have more telephone numbers to assign to Personal Speed Dial
codes, you can do so by repeating steps 5-7. Otherwise, slide the T/P switch
to the center position to return to normal operation.
9. Make a list of all Personal Speed Dial codes and the telephone numbers
they represent.