Mounting A J-Ex4200 Switch In A Recessed Position In A Rack Or Cabinet; Mounting A J-Ex4200 Switch On A Wall - Dell PowerConnect J-EX4200 Hardware Manual

Dell PowerConnect J-Series J-EX4200 Ethernet Switch Hardware Guide
Related
Documentation

Mounting a J-EX4200 Switch in a Recessed Position in a Rack or Cabinet

Related
Documentation

Mounting a J-EX4200 Switch on a Wall

100
Tighten the screws.
11.
Ensure that the switch chassis is level by verifying that all the screws on the front of
12.
the rack are aligned with the screws at the back of the rack.
If the switch is a J-EX4200-24F model, we recommend that you insert dust covers in
13.
any unused SFP ports.
Connecting Earth Ground to a J-EX Series Switch on page 115
Connecting AC Power to a J-EX4200 Switch on page 117
Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 131
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 133
Mounting a J-EX4200 Switch in a Recessed Position in a Rack or Cabinet on page 100
Rack-Mounting and Cabinet-Mounting Warnings for J-EX Series Switches on page 185
You can mount a J-EX4200 switch in a rack or cabinet such that the switch is recessed
inside the rack from the rack front by 2 inches. You can use the 2-in.-recess front brackets
provided in the separately orderable four-post rack-mount kit to mount the switch in a
recessed position.
Reasons that you might want to mount the switch in a recessed position include:
You are mounting the switch in a cabinet and the cabinet doors will not close completely
unless the switch is recessed.
The switch you are mounting has an uplink module with transceivers installed in it—the
transceivers in the uplink module ports protrude from the front of the switch.
To mount the switch in a recessed position on four posts, follow the instructions in
"Mounting a J-EX4200 Switch on Four Posts in a Rack or Cabinet" on page 96. To mount
the switch in a recessed position on two posts, follow the instructions in "Mounting a
J-EX4200 Switch on Two Posts in a Rack or Cabinet" on page 92.
Connecting Earth Ground to a J-EX Series Switch on page 115
Rack-Mounting and Cabinet-Mounting Warnings for J-EX Series Switches on page 185
You can mount a J-EX4200 switch on a wall by using the separately orderable wall-mount
kit.
Before mounting a J-EX4200 switch on a wall:
Verify that the site meets the requirements described in "Site Preparation Checklist
for J-EX4200 Switches" on page 57.