Table of Contents
Advertisement
Install the S4810–ON
To install the S4810–ON system, Dell Networking recommends completing the installation procedures in
the order presented in this chapter.
Always handle the S4810–ON and its components with care. Avoid dropping the system or its field
replaceable units (FRUs).
This chapter describes the installation procedures as follows:
1.
Installing the S4810–ON Chassis in a Rack or Cabinet
a.
Attaching the Mounting Brackets into a Two-Post Rack or Cabinet
b.
Installing the System into a Two-Post Rack or Cabinet
c.
Attaching the Mounting Brackets into a Four-Post Rack or Cabinet
d.
Installing the System into a Four-Post Rack or Cabinet
2.
Attaching the Ground Cable
3.
Installing the SFP+ and QSFP+ Optics
4.
Splitting QSFP+ Ports to SFP+ Ports
5.
Supply Power and Power Up the System
6.
After Installing the S4810-ON
WARNING: ESD damage can occur if components are mishandled. Always wear an ESD-
preventive wrist or heel ground strap when handling the S4810–ON and its components. As with
all electrical devices of this type, take all the necessary safety precautions to prevent injury when
installing this system.
Installing the S4810–ON Chassis in a Rack or Cabinet
The following sections describe how to install the S4810–ON in a rack or cabinet.
Attaching the Mounting Brackets into a Two-Post Rack or Cabinet
The S4810–ON ships with mounting brackets (rack ears) and the required screws for a two-post rack or
cabinet installation. The brackets are sent in a package with the system.
NOTE: Dell Networking recommends attaching the brackets at the power supply unit (PSU) side.
This set up provides the greatest weight support for the chassis in the rack or cabinet.
Install the S4810–ON
4
15
Advertisement
Table of Contents
