Install The S4810; Install The S4810 Chassis In A Rack Or Cabinet; Attach The Mounting Brackets Into A Two-Post Rack Or Cabinet - Dell S4810 Installing Manual

Install the S4810

To install the S4810 system, Dell Force10 recommends completing the installation procedures in the
order presented in this chapter.
Always handle the S4810 and its components with care. Avoid dropping the system or its Field
Replaceable Units (FRUs).
This chapter describes the installation procedures as follows:

Install the S4810 Chassis in a Rack or Cabinet

1

Attach the Mounting Brackets into a Two-Post Rack or Cabinet

a
Install the System into a Two-Post Rack or Cabinet
b
Attach the Mounting Brackets into a Four-Post Rack or Cabinet
c
Install the System into a Four-Post Rack or Cabinet
d
Attach the Ground Cable
2
Install the SFP+ and QSFP+ Optics
3
Splitting QSFP Ports to SFP+ Ports
4
Connect the Stacking Ports (Optional)
5
Supply Power and Power Up the System
6
WARNING: Electrostatic discharge (ESD) damage can occur if components are mishandled. Always wear
.
an ESD-preventive wrist or heel ground strap when handling the S4810 and its components. As with all
electrical devices of this type, take all the necessary safety precautions to prevent injury when installing this
system.
Install the S4810 Chassis in a Rack or Cabinet
Attach the Mounting Brackets into a Two-Post Rack or Cabinet
The S4810 is shipped with mounting brackets (rack ears) and the required screws for a two-post rack or
cabinet installation. The brackets are enclosed in a package with the system.
NOTE: Dell Force10 recommends attaching the brackets at the Power Supply Unit (PSU) side. This provides
.
the greatest weight support for the chassis in the rack or cabinet.
To attach the brackets to the system, follow these steps:
Step Task
Take the brackets and screws out of their packaging.
1
4
Install the S4810 | 19