Chassis Lifting Guidelines For J-Ex4200 Switches; Ramp Warning For J-Ex Series Switches - Dell PowerConnect J-EX4200 Hardware Manual

Dell PowerConnect J-Series J-EX4200 Ethernet Switch Hardware Guide
Related
Documentation

Chassis Lifting Guidelines for J-EX4200 Switches

Related
Documentation

Ramp Warning for J-EX Series Switches

184
¡Atención! Ver las instrucciones de instalación antes de conectar el sistema
a la red de alimentación.
Varning! Läs installationsanvisningarna innan du kopplar systemet till dess
strömförsörjningsenhet.
General Safety Guidelines and Warnings for J-EX Series Switches on page 171
Laser and LED Safety Guidelines and Warnings for J-EX Series Switches on page 177
Grounded Equipment Warning for J-EX Series Switches on page 190
Connecting AC Power to a J-EX4200 Switch on page 117
The weight of a fully loaded J-EX4200 switch chassis is approximately 22 lb (10 kg).
Observe the following guidelines for lifting and moving a or J-EX4200 switch:
Before installing a J-EX4200 switch, read the guidelines in "Site Preparation Checklist
for J-EX4200 Switches" on page 57 to verify that the intended site meets the specified
power, environmental, and clearance requirements.
Before lifting or moving the J-EX4200 switch, disconnect all external cables.
As when lifting any heavy object, lift most of the weight with your legs rather than your
back. Keep your knees bent and your back relatively straight and avoid twisting your
body as you lift. Balance the load evenly and be sure that your footing is solid.
General Safety Guidelines and Warnings for J-EX Series Switches on page 171
Installation Instructions Warning for J-EX Series Switches on page 183
Mounting a or J-EX4200 Switch on page 90
WARNING: When installing the switch, do not use a ramp inclined at more
than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10
graden.
Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.