Removing A Transceiver From A J-Ex Series Switch - Dell PowerConnect J-EX4200 Hardware Manual

Dell PowerConnect J-Series J-EX4200 Ethernet Switch Hardware Guide
Related
Documentation

Removing a Transceiver from a J-EX Series Switch

144
Slide the screwdriver out of the keyhole.
6.
Place the uplink module in an antistatic bag or on an antistatic mat placed on a flat,
7.
stable surface.
Figure 58: Sliding the Screwdriver to the Narrow Part of the Keyhole
Figure 59: Removing an Uplink Module from a J-EX4200 Switch
Installing an Uplink Module in a J-EX4200 Switch on page 108
Installing and Removing J-EX4200 Switch Hardware Components on page 105
Field-Replaceable Units in J-EX4200 Switches on page 16
Front Panel of a J-EX4200 Switch on page 6
The transceivers for J-EX Series switches are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the switch or disrupting switch functions.