Optical Interface Support In J-Ex4200 Switches - Dell PowerConnect J-EX4200 Hardware Manual

Dell PowerConnect J-Series J-EX4200 Ethernet Switch Hardware Guide
Table 17: Management Port Connector Pinout Information for J-EX4200 Switches (continued)
Pin
3
4
5
6
7
8
Related
Documentation

Optical Interface Support in J-EX4200 Switches

32
Signal
TRP2+
TRP3+
TRP3-
TRP2-
TRP4+
TRP4-
See Rear Panel of a J-EX4200 Switch on page 7 for port location.
Connecting a J-EX Series Switch to a Network for Out-of-Band Management on page 120
Optional uplink modules for J-EX4200 switches support SFP or SFP+ transceivers. This
topic describes the optical interfaces supported for those transceivers. It also lists the
copper interface supported for the SFP transceivers.
NOTE: For your J-EX4200 switch, use only the optical transceivers and optical
connectors described in this manual. For more information, contact Dell.
The Gigabit Ethernet SFP or SFP+ transceivers installed in J-EX4200 switches support
digital optical monitoring (DOM): you can view the diagnostic details for these transceivers
by issuing the operational mode CLI command
command does not give any output for copper transceivers, Fast Ethernet transceivers,
or transceivers not purchased from Dell.
The following tables describe the optical interface support over single-mode fiber-optic
(SMF) and multimode fiber-optic (MMF) cables for SFP and SFP+ transceivers and over
the copper interface for SFP transceivers:
Table 18 on page 33—Optical interface support and copper interface support for Gigabit
Ethernet SFP transceivers.
Table 19 on page 38—Optical interface support for Fast Ethernet SFP transceivers.
Table 20 on page 39—Optical interface support for Gigabit Ethernet SFP+ transceivers.
Description
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
Transmit/receive data pair 4
Transmit/receive data pair 4
show interfaces diagnostics optics
. The