Connecting The Modem To The Console Port - Dell PowerConnect J-EX4200 Hardware Manual

Dell PowerConnect J-Series J-EX4200 Ethernet Switch Hardware Guide
Table 31: Port Settings
Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control

Connecting the Modem to the Console Port

124
In the HyperTerminal window, type
5.
The modem sends an OK response to verify that it can communicate successfully
with the COM port on your desktop or notebook computer.
To configure the modem to answer a call on the first ring, type
6.
Press Enter.
To configure the modem to accept modem-control DTR signals, type
7.
prompt. Press Enter.
To disable flow control on the modem, type
8.
To set the fixed serial port speed on the modem, type
9.
Enter.
NOTE: You must set the serial port to the fixed speed so that the modem
will not adjust the serial port speed to the negotiated line speed.
To save the new modem settings, type
10.
The modem sends an OK message. The modem is now ready to be connected to the
switch.
The console port on every J-EX Series switch accepts a cable with an RJ-45 connector.
Figure 53 on page 124 shows the RJ-45 connector of the Ethernet cable supplied with the
switch.
Figure 53: Ethernet Cable Connector
Value
115200
8
None
1
None
. Press Enter.
at
at the prompt. Press Enter.
at&k0
at&b1 at the prompt. Press
at&w0 at the prompt. Press Enter.
at the prompt.
ats0=1
at&d1 at the