Installing A Transceiver In A J-Ex Series Switch - Dell PowerConnect J-EX4200 Hardware Manual

Dell PowerConnect J-Series J-EX4200 Ethernet Switch Hardware Guide
Related
Documentation

Installing a Transceiver in a J-EX Series Switch

110
Figure 41: Installing an Uplink Module in a J-EX4200 Switch
Troubleshooting Uplink Module Installation or Replacement on J-EX4200 Switches
on page 158
Removing an Uplink Module from a J-EX4200 Switch on page 142
Installing a Transceiver in a J-EX Series Switch on page 110
Installing and Removing J-EX4200 Switch Hardware Components on page 105
For information about configuring Gigabith Ethernet interfaces on the switch, see the
Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS at
http://www.support.dell.com/manuals
Front Panel of a J-EX4200 Switch on page 6
The transceivers for J-EX Series switches are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the switch or disrupting switch functions.
NOTE: For your J-EX4200 switch, use only the optical transceivers and optical
connectors described in this manual. For more information, contact Dell.
Before you begin installing a transceiver in a J-EX Series switch, ensure that you have
taken the necessary precautions for safe handling of lasers (see "Laser and LED Safety
Guidelines and Warnings for J-EX Series Switches" on page 177).
Ensure that you have a rubber safety cap available to cover the transceiver.
Figure 42 on page 111 shows how to install an SFP transceiver. The procedure is the same
for all transceiver types.
.