Bridge Configuration - Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual

3-12 WS2000 Wireless Switch System Reference Guide
• Rev. NAT (Reverse NAT)
rule, enter this value.
For Inbound, click the
translation port for the reverse NAT host.
For the Outbound direction, select the WAN (WAN1, WAN2, and so on) from the
associated with the appropriate NAT definition. (See
• Action—Choose
firewall rule is to allow or deny the specified rule.
• Log - Choose disable or enable from the pull-down menu in this field. When enabled, the following is the
behavior.
• A log entry is created every time a packet that matches this rule is denied by the action "Deny".
• A log entry is created once per session for packets that match this rule is allowed access by the
action "Allow".

3.5 Bridge Configuration

Bridges are data link layer devices. They operate at the Layer 2 of the OSI reference model. Bridges are
generally used to connect different segments of the same network.
To configure Bridging, select
The Bridge Config (Bridge Configuration) screen appears.
To configure the bridge:
1. Set the Priority
mesh network to defer to this client bridge as the bridge defining the mesh configuration (commonly
referred to as the root). Motorola recommends assigning a Base Bridge AP with the lowest bridge priority
so it becomes the root in the STP. If a root already exists, set the Bridge Priorities of new APs accordingly
so the root of the STP does not get altered. Each access point starts with a default bridge priority of
32768.
(inbound) / NAT
Rev. NAT field and a new window will pop up to enter the IP address and
Allow or Deny from the pull-down menu in this field to determine whether the
Network Configuration --> LAN -->
for the bridge. Set the Priority
(outbound)—To enable NAT or reverse NAT for a firewall
Configuring Network Address Translation
<subnet> and select the Bridging tab.
as low as possible for a to force other devices within the
NAT field menu that is
(NAT)).