Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual page 170

7-28 WS2000 Wireless Switch System Reference Guide
Select System Configuration
appars.
1. The field on the left of the Current Time area displays what the switch believes is the current time. Click
the Refresh
network to update its current time.
2. Specify a time zone by selecting the appropriate zone from the
3. To set the time manually, click the
WS2000's time.
NOTE: When NTP is enabled on the WS2000, you will not be able to set time manually.
4. To enable time service on the switch, check the
the rest of the steps below.
5. Specify a Preferred Time
Alternate Time Server
default port is 123. The more NTP servers specified, the greatest assurance there is of uninterrupted time
synchronization.
6. Specify a Synchronization Interval
15 minutes.
7. Click the Apply
--> NTP Servers
button to update that time. If an NTP server is configured, the switch will go out to the
Set Date/Time
Server, and optionally a
by specifying the IP address and Port for the time service for each server. The
(in minutes). By default, the switch will synchronize the time every
button to save any changes made on this screen.
from the left menu to enable NTP. The NTP Server screen
Time Zone
button. A sub-window displays where you can set the
Enable NTP on WS 2000
First Alternate Time Server
list.
checkbox and continue with
and a Second